2MM CS X 10MM ID BLACK EPDM 70D

This o-ring is supplied in black EPDM (EPR) 70 Shore A measuring an inside diameter of 10 mm (0.394 in), a cross section of 2 mm (0.079 in), and an outside diameter of 14 mm (0.55 in), catalogued under part number E2X10. It seats in a machined groove and forms a leak-tight barrier when compressed between two mating surfaces.

EPDM (EPR) offers good electrical insulating characteristics and very good flexibility at low temperature. The material holds up against ozone, UV and weathering, brake fluid, and ketones. Published continuous service range is -65°F (-53.9°C) to 300°F (148.9°C). Exposure to petroleum oils and fuels or mineral oil-based lubricants will shorten service life.

Typical settings include brake and phosphate ester systems, water and steam systems, and outdoor equipment.

Stocked as E2X10 and sold individually. Unit weight is approximately 0.132 g. Application requirements vary, so validate compatibility with your process conditions prior to installation. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.