1MM CS X 3.5MM ID BLACK EPDM 70D

Part number E1X3.5 is a black EPDM (EPR) 70 Shore A O-Ring built to an inside diameter of 3.5 mm (0.138 in), a cross section of 1 mm (0.039 in), and an outside diameter of 5.5 mm (0.22 in). An o-ring compresses into its gland to block fluid or gas migration across a joint.

As a material, EPDM (EPR) is widely chosen for strong performance in outdoor and exposed installations, very good flexibility at low temperature. This material stands up to ketones, ozone, UV and weathering, and dilute acids and alkalis. Service temperature is rated from -65°F (-53.9°C) through 300°F (148.9°C).

Typical settings include potable water applications, water and steam systems, and solar and roofing assemblies.

Reference part number E1X3.5 when ordering; the item is sold individually. Unit weight is approximately 0.0144 g. As always, verify media compatibility and operating conditions against the requirements of your specific application. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.