-017 BLACK EPDM 80D O-RING

This o-ring is supplied in AS568-017 black EPDM (EPR) 80 Shore A measuring an inside diameter of 0.676 in (17.17 mm), a cross section of 0.07 in (1.78 mm), and an outside diameter of 0.816 in (20.73 mm), catalogued under part number E80PC017. It creates a positive seal at flange, piston and rod interfaces without added hardware.

EPDM (EPR) is specified here for very good flexibility at low temperature, strong performance in outdoor and exposed installations. The material holds up against ozone, UV and weathering, phosphate ester hydraulic fluids, and brake fluid. The material carries a published service range of -65°F (-53.9°C) to 300°F (148.9°C). Verify compatibility before use with aromatic hydrocarbons or mineral oil-based lubricants.

You will find this material specified across solar and roofing assemblies, outdoor equipment, and water and steam systems.

This item is sold individually under part number E80PC017. As always, verify media compatibility and operating conditions against the requirements of your specific application. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.