1.5MM CS X 29.5MM ID BLACK BUNA 70D

This o-ring is supplied in black Buna-N (Nitrile) 70 Shore A built to an inside diameter of 29.5 mm (1.161 in), a cross section of 1.5 mm (0.059 in), and an outside diameter of 32.5 mm (1.28 in), catalogued under part number H1.5X29.5. It creates a positive seal at flange, piston and rod interfaces without added hardware.

It resists many alcohols, water, and propane and butane. That behavior comes from the compound itself: Buna-N (Nitrile) delivers low compression set under sustained load, strong abrasion and tear resistance. Service temperature is rated from -40°F (-40°C) through 250°F (121.1°C). Verify compatibility before use with ozone and direct sunlight or ketones.

Typical settings include general industrial maintenance, hydraulic and pneumatic systems, and fluid power.

This item is sold individually under part number H1.5X29.5. Unit weight is approximately 0.2161 g. As always, verify media compatibility and operating conditions against the requirements of your specific application. Not finding the exact configuration you need? APG cross-references from prints, samples and competitor part numbers.