1MM CS X 6MM ID BLACK BUNA 70D

The H1X6 is a black Buna-N (Nitrile) 70 Shore A O-Ring measuring an inside diameter of 6 mm (0.236 in), a cross section of 1 mm (0.039 in), and an outside diameter of 8 mm (0.31 in). This o-ring creates a positive seal at flange, piston and rod interfaces without added hardware.

As a material, Buna-N (Nitrile) is known for low compression set under sustained load, strong abrasion and tear resistance. The material holds up against propane and butane, water, and hydraulic fluids. Published continuous service range is -40°F (-40°C) to 250°F (121.1°C). Exposure to strong acids or ozone and direct sunlight will shorten service life.

Typical settings include hydraulic and pneumatic systems, fluid power, and agricultural equipment.

This item is sold individually under part number H1X6. Unit weight is approximately 0.0223 g. Check the compound against your process media, pressure and temperature before committing to a design. APG supports cross-referencing from drawings, samples and competitor numbers when a listed size is not an exact fit.