2.4MM CS X 15.6MM ID BLACK BUNA 90D

H90M2.4X15.6 is a black Buna-N (Nitrile) 90 Shore A O-Ring with an inside diameter of 15.6 mm (0.614 in), a cross section of 2.4 mm (0.094 in), and an outside diameter of 20.4 mm (0.8 in). In service, this o-ring creates a positive seal at flange, piston and rod interfaces without added hardware.

Buna-N (Nitrile) is valued for low compression set under sustained load and an economical choice for high-volume maintenance programs. It resists propane and butane, water, and petroleum-based oils. The material carries a published service range of -40°F (-40°C) to 250°F (121.1°C). It is not the right choice where strong acids or ketones are present.

It sees regular use in general industrial maintenance, construction equipment, and hydraulic and pneumatic systems.

Stocked as H90M2.4X15.6 and sold individually. As always, verify media compatibility and operating conditions against the requirements of your specific application. APG can cross-reference from an existing part number, a drawing or a physical sample if this size is not an exact match.