1.5MM CS X 2MM ID RED SILICONE 70D

The S1.5X2 is a red Silicone 70 Shore A O-Ring measuring an inside diameter of 2 mm (0.079 in), a cross section of 1.5 mm (0.059 in), and an outside diameter of 5 mm (0.2 in). This o-ring remains the most cost-effective sealing element available for pressurized assemblies.

Silicone is valued for very good compression set resistance across its range and flexibility that holds at very low temperatures. The compound resists weathering, many oxidizing chemicals, and extreme heat and cold. Service temperature is rated from -80°F (-62.2°C) through 450°F (232.2°C). Verify compatibility before use with concentrated acids or steam above its rated range.

This item meets FDA requirements for food contact. Typical settings include medical devices, electronics and electrical enclosures, and sanitary process lines.

S1.5X2 ships individually. Unit weight is approximately 0.0262 g. Application requirements vary, so validate compatibility with your process conditions prior to installation. If you need a size, durometer or compound that is not listed, APG can cross-reference from a print, a sample or a competitor part number.